Tabla de contenido
Idiomas disponibles
Idiomas disponibles
► If only a small amount of water is dispensed, then the desired temperature may differ.
Preheat the vessel.
► If device was not used for longer time there could be scale deposits despite water filter. In
this case let 100 ml with 100 °C run through the device.
► The device has a memory function if the plug is still plugged in. The settings, that were
adjusted the last time, are still adjusted. The settings will be reset after unplugging.
► The ambient temperature changes everyday. This leads to different
amounts of water. It can vary up to +- 15%.
14.2.1
Water disposal from the drip tray
1. When the drip tray is full, grasp and stabilize the device by one hand
and use the other hand to lift up the drip tray slightly to remove it.
2. Empty the drip tray and insert it into the original place. Make sure it is
properly inserted.
14.2.2
Replacing the waterfilter
14.2.3
Error code Lo Lack of water
If the device stops to operate with a beeping sound and the display shows the error code Lo
Lack of water, it means that there is too little water or no water in the water tank. Please fill
in enough water into the water tank immediately.
14.2.1
Calibration
If you want to optimize the temperature or volume of water, then you can calibrate the device.
Fill the tank up to max marking.
Place vessel below the spout which can collect whole content of watertank.
Press and hold
"000" is shown press Start/Stop for confirmation. The device perfoms the calibration and
beeps once process is finished.
Please note
Temp-button for 3 seconds until „CAL" is displayed. When volume
1.
Open the tank cover (A) and take out the filter
box (B) with the old waterfilter (C).
2.
Soak the new waterfilter upright in water for 10
min.
3.
Rinse the new waterfilter thoroughly under
running water.
4.
Remove the old waterfilter and replace it with
the new waterfilter (see fig.). Therefor take out the
filter box, place the new waterfilter and pull it down
from the bottom.
35
Tabla de contenido
