Set The Water Hardness; Use - CASO DESIGN HW 600 Manual Del Usuario

5. Turn to 100°C temperature setting with continuous water flow and let the device dispense
water.
6. When device shows Lo Lack of water (watertank is empty), then the process is finished.
7. The device can now be equipped with waterfilter and filled with fresh water.
8. The device is ready for use.
14.1.3

Set the water hardness

Press and hold
stands for soft water. This means that „Descale" will light up in the display after 60 litres of
water were dispensed. „002" stands for hard water. This means that "Descale" will light up in
the display after 25 litres of water were dispensed. With the
change between „001" and „002" confirm with Start/Stop.

14.2 Use

1. Fill the watertank with water, you can remove it to do this.
2. Place your cup on the removable drip tray, make sure it aligns with the spout.
3. First press
4. Press Temp-button to choose your desired temperature and press
button to set the water volume.
5. Press Start/Stop-button to start the device. The desired water volume will flow out from
water spout. Press Start/Stop-button again, to stop the device. The device will stop
working at once.
6. Alternatively: Press and hold
preparation of baby food. Water with 40°C will be dispensed as long as button is pressed.
► Do not fill milk into the device.
Warning
► Avoid the risk of burns: Please check the temperature of the food before you give it
to your baby. This can easily be done on the back of your hand.
If you want to dispense water again, repeat the steps above.
7.
Clean-button, the display shows „001" or „002" as Volume. „001"
Lock-button about 3-5 seconds for unlocking the device,.
Baby-button for dispensing of water with 40°C for
Please note
Volume-button you can
Volume-
34