Set Up And Use Of The Appliance - Dalla Corte Studio Manual De Usuario

3. Set up and use of the appliance

NOTE
Before switching on (the machine must be disconnected from the power
grid) clean the external surfaces of the machine, wash the grids, filters, filter
holders, steam nozzles with dishwashing detergent and rinse thoroughly.
Carry out the following instructions by consulting the diagram shown in fig.2,
fig.1b for the JUG version and fig.1a for the WATER SUPPLY version.
• WATER SUPPLY VERSION: Open the water supply cock (1 fig.1a).
• JUG VERSION: Fill the machine tank as shown in punto 3.1.
• Connect the plug to the mains electricity.
• Turn on the main switch of the appliance (1 fig.2); then make sure the di-
splay is on.
• As soon as the appliance is switched on, the automatic self-level starts
filling the boiler until reaching the operating level.
• Once the loading phase is completed, the supply unit starts to heat up, and
the heating unit indicator light L1 will start to flash.
• At the end of the unit heating phase the value shown on the display will
stop flashing, showing the temperature value set in the unit and the other
parameters specified in paragraph 7.
• DISPLAY: At the same time, the boiler will start heating.
NOTE
In this manner it is already possible to brew from the unit and prepare the
espresso while all the functions connected to the boiler are inhibited.
| 59