john deer AC1-CG16H Manual Del Usuario página 18

It is recommended to:
1. Use electrical devices with 3 prong power cords.
2. Use an extension cord with a 3 hole receptacle and a 3 prong
plug at the opposite ends to ensure continuity of the ground
protection from the unit to appliance.
John Deere strongly recommend that all applicable federal, state
and local regulations relating to grounding specifications be
checked and followed.
LINE TRANSFER SWITCH:
If this unit is used for standby service, it must have a transfer switch
between the utility power service and the unit. The transfer switch
not only prevents the utility power from feeding into the unit, but
also prevents the unit from feeding out into the utility company's
lines. This is intended to protect the serviceman who may be
working on a damaged line.
THIS INSTALLATION MUST BE DONE BY A LICENSED
ELECTRICIAN AND ALL LOCAL CODES MUST BE FOLLOWED.
ENGINE
Review "Risk of Fire or Explosion" before fueling. Read the
engine manual accompanying this unit for correct engine start-up
maintenance procedures. Read and understand the safety labels
located on the unit.
WARNING: RISK OF EXPLOSION OR FIRE CAUSING
SERIOUS INJURY OR DEATH! DO NOT SMOKE
WHILE FUELING!
DO NOT FILL FUEL TANK WHILE THE UNIT IS
RUNNING OR HOT. ALLOW THE UNIT AND
ENGINE TO COOL DOWN FOR TWO MINUTES
BEFORE REFUELING.
DO NOT FILL FUEL TANK TO POINT OF
OVERFLOWING.
1/4" OF TANK SPACE FOR FUEL EXPANSION.
DO NOT PLACE UNIT IN AN AREA WHERE
FLAMMABLE GAS VAPORS MAY BE PRESENT.
A SPARK COULD CAUSE AN EXPLOSION OR
FIRE.
ALWAYS STORE FUEL AWAY FROM THE
UNIT WHILE IT IS RUNNING OR HOT.
WARNING: RISK OF EXPLOSION OR FIRE CAUSING
SERIOUS INJURY OR DEATH DO NOT ALLOW THE
ENGINE OR MUFFLER TO COME IN CONTACT
WITH FLAMMABLE VAPORS, COMBUSTIBLE DUST,
GASES OR OTHER COMBUSTIBLE MATERIALS. A
SPARK MAY CAUSE A FIRE.
18
Installation
ALLOW APPROXIMATELY
Operator's Manual