Ariens Zoom 2452 HD Manual Del Propietario - Operador página 9

NEVER attempt tomake a ny adjustments to
unit while e ngine isrunning (except where
specifically recommended). Stop e ngine,
remove key orspark plug w ire and wait f or a ll
moving parts tostop b efore servicing or
cleaning.
Check parking brake operation frequently.
Adjust and service asrequired.
ALWAYS maintain unit i nsafe operating
condition. Damaged orworn o ut m uffler can
cause fire orexplosion.
Maintain orreplace safety and instruction
labels, asnecessary.
NEVER store u nit with fuel infuel tank, inside
abuilding where a ny ignition sources are
present.
Shut off f uel and allow engine tocool
completely before storing inclosed area o r
covering unit.
Clean grass and debris from unit, especially
from around muffler and engine, tohelp
prevent fires.
For e xtended storage, shut off f uel and clean
unit t horoughly. See e ngine manual for p roper
storage.
Lower cutting deck u nless apositive
mechanical lock isused.
Use only a ttachments oraccessories
designed foryour unit.
Check allhardware atregular intervals,
especially blade attachment bolts. Keep all
hardware properly tightened.
Check attachment components frequently. If
worn o rdamaged, replace with
manufacturer's recommended parts.
I'-'_,$1=1 _v_ I:] t'l
WARNING: AVOID INJURY.
Read and understand entire
Safety section before proceeding.
UNIT ASSEMBLY
Package Contents:
Unit, Mower Deck and Literature Pack
Preparation Checklist
Refer to the Owner/Operator manual as
required.
1. Unpack Unit - Remove shrink wrap and
packaging materials.
2. Remove Unit From Container - Open
Bypass Valves (dump valves) (See
Moving the Unff with the Engine Off on
page 15).
Push unit from container onto a level
surface. Close the bypass valves.
3. Tires - See Specifications on page 30.
_1 AUTION: Avoid injury! Explosive
separation of tire and rim parts is
possible when they are serviced
incorrectly:
Do not attempt to mount a
tire without the proper
equipment and experience
to perform the job.
Do not inflate the tires
above the recommended
pressure.
Do not weld or heat a wheel
and tire assembly. Heat can
cause an increase in air
pressure resulting in an
explosion. Welding can
structurally weaken or
deform the wheel.
Do not stand in front or over
the tire assembly when
inflating. Use a clip-on
chuck and extension hose
long enough to allow you to
stand to one side.
4. Seat - See Seat Adjustments on
page 13 and Service Position on
page 17.
5. Position Steering Levers- Rotate
eccentric spacers to align handlebars.
Tighten hardware securely. See Aligning
the Steering Levers (Figure 14) on
page 23.
6. Battery - Remove battery from unit and
charge (See Battery on page 21 ).
GB-9