Milnor 36026X8J Manual De Instrucciones página 37

Maintenance Components—Large Extractors
3.1.6.
Figure 14: Grease Ports for Grease-only Bearing Assembly
Grease Plate 01-10025X, 01-10025Y, or 01-10025Z
.
Figure 15: Suspension Components on Each Side of Rubber Spring-Hung Washer-extractors
Suspension Shaft
1. Grease ports on ball bushings (two on each side of the machine)
2. If cracks occur in the rubber, the rubber spring must be replaced.
3. If fluid comes out here or on the shaft, the seals are worn. The shock absorber must be replaced.
.
Rubber Spring
Legend
— End of BIUUUM09 —
33
Chapter 3. Routine Maintenance
[Document BIWUUM03]
Legend
1. Seal grease port
2. Rear bearing grease port
3. Front bearing grease port
4. Grease plate part number.
Make sure you use the
grease instructions for the
plate on your machine:
01-10025X, 01-10025Y,
or 01-10025Z.
Shock Absorber
PELLERIN MILNOR CORPORATION