Samsung LN S4692D Manual De Instrucciones página 9

Ocultar thumbs Ver también para LN S4692D:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Installing
Batteries
in the Remote
Control
t.
Lift the cover at the back of the remote control upward as shown in the figure.
2.
Install two AAA size batteries.
Make sure to match the "+" and "-" ends of the batteries with the diagram inside the compartment.
3.
Replace the cover.
Remove the batteries and store them in a cool, dry place if you won't be using the remote control for a long time.
The remote control can be used up to about 23 feet from the TV.
(Assuming typical TV usage, the batteries last for about one year.)
:_ If the remote control doesn't work, check the following:
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power outage, or is the power cord unplugged?
5. Is there a special fluorescent light or neon sign nearby?
Connections
Connecting
VHF and UHF Antennas
if your anlcnna has a set of leads that look like This, see "Anlcnnas with 300 _ Flat Twin Leads"
below.
if your anlenna
has one lead that looks like This, see "Antennas
with 75 g_ Round Leads".
if you have two anlennas,
see "SeparaTe
VHF and UHF Anlennas".
Antennas
with 300 _ Flat Twin Leads
if you are using an off-air amenna (such as a roof anlenna or "rabbit ears") that has 300 Q twin fiat leads, follow the directions below.
t.
Place the wires from the twin leads under the screws on a 300-75 _ adapter
(not supplied).
Use a screwdriver to tighten the screws.
2.
Plug the adaptor into the ANT 2 IN (CABLE) terminal on the back of the TV.
Antennas with 75 _ Round Leads
1.
Plug the antenna lead into the ANT 1 IN (AIR) terminal on the back of the TV.
Separate
VHF and UHF Antennas
if you have two sepm'ate anlennas for your TV (one VHF and one UHF), you must combine the two antenna signals before connecting
the antennas to the TV. This procedure requires an optional combinel=adaptor (available at most eleclronics shops).
]_(_
1.
Connect both antenna leads to the combiner.
2.
Plug the combiner into theANT 1 IN (AIR) terminal on the bottom of the rear panel.
English-7
Tabla de contenido
loading

Tabla de contenido