Honeywell T6 Pro Hydronic Serie Instrucciones De Instalación página 2

Read before installing
Optional Cover Plate installation
NOTE: If Optional Cover Plate is not required,
see "UWP Mounting System installation" below.
Use the Optional Cover Plate when you need to
cover paint gap from the old thermostat.
There are different cover plates depending on
when the thermostat was manufactured.
One plate is square, the other is rectangular.
1. If the square mounting plate is used,
separate the cover plate from the mounting
plate. See Figure 1.
2. Mount the mounting plate to the wall using
any of the screw holes. Insert and tighten
mounting screws supplied with the cover
plate. Do not overtighten. Make sure the
mounting plate is level. See Figure 2a
(square) or 2b (rectangle).
3. Attach the UWP by hanging it on the top
hook of the mounting plate and then
snapping the bottom of the UWP in place.
See Figure 3.
4. For square cover plate, snap the Cover Plate
onto the mounting plate. See Figure 4.
UWP Mounting System installation
5. Before starting, turn the power off
at the breaker box or switch. Open
package to find the UWP. See Figure 5.
6. Position the UWP on wall. Level and
mark hole positions. See Figure 6.
Drill holes at marked positions, and
then lightly tap supplied wall anchors
into the wall using a hammer.
‒ If your box contains red anchors, use
a 7/32" (5.6 mm) drill bit. If your box
contains yellow anchors, use a 3/16"
(4.8 mm) drill bit.
7. Pull the door open and insert the wires
through wiring hole of the UWP. See
Figure 7.
8. Place the UWP over the wall anchors.
Insert and tighten mounting screws
supplied with the UWP. Do not
overtighten. Tighten until the UWP
no longer moves. Close the door. See
Figure 8.
1
Use 2x
supplied
screws #6
5/8"
2a
3
5
7
2
2b
4
6
8
Use 3x supplied screws
(#8 1-1/2 for red
anchors and
#6 1-1/2 for yellow
anchors)