Honeywell 32003971-003 Manual Del Usario

General Purpose Temperature
Sensor
APPLICATION
Single element 10KOhm resistive temperature sensor
used with the Honeywell Domestic Hot Water Module
AquaReset system. Single element sensors provide only
operation temperatures for a variety of temperature
sensing applications including Domestic Hot Water
Module detection.
Sensor
Function Description
Water Tank • Single Element NTC
Inlet/Outlet • 10K Ohm ± 1% at
25 °C
• β=3950 for 25 °C to
66 °C
NOTE: Use 22 AWG two-wire twisted pair, insulated for low voltage such as Belden 8443 or equivalent and limit cable
length to 50 feet (15.24 meters).
FEATURES
• NTC resistive 10K Ohm ± 1% at 25 °C temperature
• Sensor β=3950 for 25 °C to 66 °C (β=thermistor
• Single element sensors for water tank inlet/outlet,
• 32003971-003 sensor kit contains sensor and
• Sensors may be used for either strap-on or
• Compatible immersion wells and accessories
SPECIFICATIONS
Sensors may be used in strap-on applications.
Complementary parts such as immersion wells, mounting
clamps and spring clips can be found in Honeywell form
#68-0040, Immersion Wells and Compression Fittings.
The immersion wells and other complementary parts
must be ordered separately.
Table 1. DHW Module Sensors.
Temperature
Range Termination
42 in. leads,
wires skinned
-40 to +266 °F and retained
-40 to +130 °C
INSTALLATION INSTRUCTIONS
sensors.
material constant relative to its resistance versus
temperature)
boiler inlet, header and outdoor temperature
sensing functions.
hardware for strap-on or outdoor mounting of
sensor.
insertion type applications.
available. Refer to Honeywell form number 68-
0040 for more information.
Part Number
32003971-003
Kit includes
sensor, anchors,
mounting screws,
wire nuts, clip, tie
straps
Installation
Information
• 2.620 ± 0.015 in.
insertion
• 0.375 ± 0.002 in.
bulb diameter
• Bulb material copper
69-2344EFS-01