Transportation; Checking The Floor Where The Appliance Will Be Placed; Preparing The Place Of Installation; General Considerations - Palazzetti JP Serie Manual De Instalación Y Mantenimiento

4.2 Transportation

Make sure that the lifting carriage has a
payload higher than the weight of the
appliance to be lifted. The full responsi-
bility of the lifting of loads lies with the
person handling the lifting equipment.
Pay particular attention to protecting
wooden flooring or parquet floors in
order to avoid possibly ruining them
due to the weight of the appliance
when moving it.
During lifting, avoid jerking or abrupt movements.
Pay attention to overbalancing.
4.3 Checking the floor where the
appliance will be placed
Check the load capacity of the floor slab.
If a floor is not suitable for supporting the
weight of the appliance, install appropriate
steel plates (A - Fig. 4) or concrete base (A - Fig.
5) equipped with
mesh (B - Fig. 5) to distribute the weight.
For the dimensions of the plates and
the concrete base, use a qualified
technician.
A
004778300 ­ 14/09/2020
ITALIANO ENGLISH
10x10x6 electro­welded
10 mm
Fig. 4
DEUTSCH
A
B
5 pREpARING THE pLACE
OF INSTALLATION
5.1

General considerations

In the following paragraphs there are some
indications to be respected in order to obtain
the maximum performance of the purchased
product and its safe operation. The following
indications are however subject to compliance
with any possible national, regional and munic­
ipal laws and regulations in force in the country
where the appliance is installed.
Installation must be carried out by qualified staff
in compliance with standard EN 10683.

5.2 Safety precautions

The operations for assembly and disassembly of
the appliance are reserved for specialist techni­
cians only.
It is recommended to be sure of their qualifica­
tions and their actual capacity.
For Italy, these technicians must be in
possession of the letter "C" qualification
issued by the chamber of commerce
based on the Ministerial Decree. 37/08.
The person in charge of the installation, before
starting assembling or disassembling the ma­
chine, must comply with the safety precautions
required by law and in particular with the below:
• the person must not operate in adverse work­
ing conditions;
• the installer must operate in perfect psycho­
physical conditions and must check that the
personal protective equipment is intact and
functioning perfectly;
• the installer must wear safety gloves and shoes;
• they must make sure that the area used during
assembly and dismantling is free from obstacles.
FRANÇAIS ESPAÑOL
Fig. 5
37