FTE Maximal ATLAS 64 Manual De Instalación Rápida página 28

Quick installation Guide ATLAS 64
Extended: Mark the checkbox +1V to increase the supply voltage 1 volt. Use this option when
the input voltage in the remote device is low for example for a high value of electrical resistance
in long cables.
Tone: Select between OFF and 22 KHz.
DiSEqC: Choose between A, B, C and D.
Band: In this option select between Ku band (LO 9750/10600MHz), C band (LO 5150), S band
(LO 3620), Ku band (LO 10750) and Ku band (LO 11300).
Enable: If the option is checked the input is enable.
Press the button Apply to update the change in the device.
6.2.2. Tuner
This section allows change the settings of the 6 tuners of the headend and show information of
the transponder tuned. First step is choose the Tab of the tuner to change the settings.
Input Selection: Select in the list the RF between the 4 available inputs.
Frequency (MHz): Enter the frequency in MHz.
Baud Rate (KBd): Type the value of the Symbol rate.
Modulation: Choose in the list between DVB-S and DVB-S2.
Enable: Check this option to enable the tuner.
Press Apply to confirm. After tune the signal of the transponder in the screen appears the
information of the input level, the quality, the input network information and the service list.
9
- -
All right of technical changes and mistakes are reserved. ATLAS 64 Version en_1.1 Fte maximal