Klarstein 10031694 Manual De Instrucciones página 20

EN
20
• Do not pull the plug out of the socket by the cord, but rather hold the plug in your
hand when removing it.
• If the power cord or the plug are damaged, they must be replaced by the
manufacturer, an authorized specialist company or a similarly qualified person.
• When you move the device, make sure that the power cord is not damaged.
Important notes on the use of extension cords
If possible, do not use an extension cord. If you use one, make sure that the amperes of
the connected device do not exceed the maximum amperage of the power cord.
Installation of the handles
The wine cooler comes with 2 stainless steel handles. Install the handles as follows:
1 Remove the door gasket from left side of the door where you want to install the
handle (see picture). You do not need a tool; the gasket can be removed by hand. If
the gasket is difficult to remove in the middle, start at the corner.
2 Remove the screws, the flat washers and the lock washer from the bag containing
the instruction manual. Place the parts on the door from the inside out, as shown in
the diagram.
3 Align the holes in the handle with the screws, and tighten the screws with a
screwdriver until the handle is firmly seated on the door. Do not overtighten the
screws.
4 Replace the gasket.
1 Gasket
2 Flat washer
3 Lock washer
4 Screw
5 Handle
6 Door frame