Tabla de contenido
®
R&S
Cable Rider ZPH
● Side strap
● Printed Getting Started manual
● Document folder containing safety instructions and calibration certificate
Optional accessories and their order numbers are listed in the data sheet.
3.1.3
Setting up the R&S Cable Rider ZPH
The R&S Cable Rider ZPH is mainly used for diagnostic purpose during the
installation of RF feeder cables and antennas for all kinds of radio transmitters.
Depending on the environment, you can adjust the viewing angle of the display
and either lay it out horizontally or prop it up using the support on the back of the
R&S Cable Rider ZPH.
When laid out horizontally for operation from above, the R&S Cable Rider ZPH is
tilted slightly due to the micro-stand at the back. This position provides the opti-
mum viewing angle for the display.
To allow easy operation from the front and still be able to read the display, you
can swing out the support on the back of the R&S Cable Rider ZPH.
Before you turn on the R&S Cable Rider ZPH, you should insert the lithium ion
battery included in the delivery into the battery compartment located at the back
of the R&S Cable Rider ZPH.
Insert battery
Getting Started 1321.0944.02 ─ 04
Preparing for Use
Putting into Operation
11
Tabla de contenido
