Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CONNECTION DIAGRAM
SPEAKER OR
AMP SYSTEM
(MONITOR)
Please study the connection diagram above.
1.
Connect the OMNI CONTROL's USB PORT to an available USB2.0 port on your computer, using the included
USB2.0 cable. The OMNI CONTROL will be powered through your computer's USB bus.
2.
(Optional) You can power the OMNI CONTROL by connecting an optional 6V 1A power adapter to the DC IN
input on the OMNI CONTROL. Please note that it is not necessary to have the adapter plugged in for the OMNI
CONTROL to work. However, you should connect this adapter if your computer is not able to supply enough
power to the OMNI CONTROL.
3.
Connect the OUTPUT 1 on the OMNI CONTROL to your main speaker or amplifier system, using a stereo RCA
cable.
4.
(Optional) Using a stereo RCA cable, connect the OUTPUT 2 on the OMNI CONTROL to a secondary speaker
or amplifier system to be used for monitoring purposes.
5.
Connect your headphones to the HEADPHONES output on the OMNI CONTROL. The signal output from
HEAPHONES will be the same as the signal being output from OUTPUT 2.
6.
Connect your microphone to the MIC THROUGH input on the OMNI CONTROL.
REAR PANEL CONNECTIONS
1.
USB PORT – Please use the supplied
USB2.0 cable to connect this port to an
available
USB2.0
computer.
When plugged into your
computer, the unit will draw power from
the USB connection.
Please note: The OMNI CONTROL requires a USB2.0 connection in order to function fully and properly. If using
a USB1.1 connection, only OUTPUT 1 will work. To take advantage of both outputs, please make sure that you
are connecting to a USB2.0 compatible port on your computer.
2.
DC IN – If your computer does not supply enough power through the USB bus, you may wish to power the unit
externally by connecting an optional 6V/1A adapter to this input and plugging the adapter into a power supply.
3.
OUTPUT 1 – This stereo RCA connection will output the Master Mix from your computer. Please use a stereo
RCA cable to connect this output to a powered speaker or amplifier system.
4.
OUTPUT 2 – This stereo RCA connection will output the Cue Mix from your computer for monitoring purposes.
Please note that the Cue Mix is also output through the Headphone Output on the front panel.
FRONT PANEL CONNECTIONS
1.
MIC THROUGH INPUT – This is a ¼"
microphone input. The signal from this
input will be sent directly to the Output
1 (Master Mix) RCA output.
2.
MIC VOL – This knob controls the
microphone level being sent to Output
1 (Master Mix).
3.
HEADPHONES – This stereo ¼" output will output the signal being routed to Output 2 (Cue Mix). To take full
advantage of cueing and monitoring through this output, please make sure that you have routed the Cue Mix in
your software to Output 2 of the OMNI CONTROL.
SPEAKER OR
AMP SYSTEM
(MASTER)
HEADPHONES
port
on
your
COMPUTER
4
2
1
3
6
POWER
SUPPLY
(OPTIONAL)
MICROPHONE
3
2
1
Tabla de contenido
