Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
Remove packing sheet from the back of the sleeve, and
packing corner and blue tape from the air conditioner.
INSTALLATION REQUIREMENTS
If you use an existing
wall sleeve, you should
measure
its dimensions.
Install the new air conditioner
according
to these
installation
instructions
to achieve
the best
performance.
All wall sleeves
used to mount
the
new air conditioner
must be in good structural
condition
and have a rear grille to securely
attach
the new air conditioner.
(FIG. 1)
With the LGE sleeve(optionally
supplied
with your
unit), you can maintain
the best performance
of the
new air conditioner.
(FIG. 2)
t3/32"
6 ram)
Air Conditioner
16"(456
ram)
\_-.
25_7/_.
(656 mm)
FIG. 1
Expanded
aluminum metal grill_
LGE Wall Sleeve
(425ram)
FIG. 2
ELECTRICAL
SERVICE
Check
your available
electrical
service.
The power
supply
available
must be the same
as that shown
on the unit nameplate
(found on left side of
cabinet).
All models
are equipped
with a 3-prong
service
plug to provide
proper
service
and safe positive
grounding.
Do not change
plug in any way. Do not
use an adapter
plug. If your present
wall outlet
does
not match your plug, call a qualified
electrician
to
make
the necessary
corrections.
SAVE CARTON
for storage
and this OWNER'S
MANUAL
for future
reference.
The carton
is the best way to store unit
during
winter or when
not in use.
INSTALLATION
HARDWARE
2 Size options
2 Size options
ITEM
NAME OF PARTS
Q'TY
_1_
PLASTIC GRILLE
1
_2_
HORIZONTAL INSULATION STRIPS
2
_3_
AROUND INSULATION STRIPS
2
_4_
SUPPORT BLOCK
2
_5_
BAFFLE
1
<6_
TRIM FRAME
2
_7_
SHIM
2
_
PLASTIC NUTS AND WASHER SCREWS
4
_, CAUTION
To avoid risk of personal injury, property damage, or product
damage due to the weight of this device and sharp edges
that may be exposed:
• Air conditioners covered in this manual pose an excessive
weight hazard. Two or more people are needed to move
and install the unit.
To prevent injury or strain, use proper lifting and carrying
techniques when moving unit.
• Carefully inspect location where air conditioner will be
installed. Be sure it will support the weight of the unit over
an extended period of time.
• Handle air conditioner with care. Wear protective gloves
whenever lifting or carrying the unit. AVOID the sharp
metal fins of front and rear coils.
• Make sure air conditioner does not fall during installation.
REQUIRED
TOOLS:
• Tight Fitting gloves
• 3/8-inch
open end
• Standard
screwdriver
wrench
or adjustable
wrench
• Phillips screwdriver
• 1/4-inch
hex socket
• Pliers
and ratchet
• Sharp
knife
• Tape measure
• Electric
drill
• 1/4-inch
drill bit
@
Owner's Manual
11
Tabla de contenido
