Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Tools and Parts
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Measuring tape
Pencil
■
■
7/64" drill bit
Drill
■
■
Screw Pack Supplied (not shown to scale)
SCREW
#7-18x7/16" round-head sheet metal
screw
#7-16x15/16" flat head wood screw
#7-16x7/16" round-head wood screw
NOTE: There are some extra screws in the screw pack. They are
spares for your use during installation if needed. See below:
#7-18x7/16" round-head sheet metal screw: 4 extra.
■
#7-16x15/16" flat head wood screw: 2 extra.
■
#7-16x7/16" round-head wood screw: 4 extra.
■
Parts Supplied (not shown to scale)
This installation instruction is for various models. Some parts
supplied may have different appearance, depending on your
model.
NOTE: Trim kit frame (1), Cooling Ducts (2) and Rail (2) parts will
need to be purchased to convert from Standard to Slim or from
a Slim to a Standard installation.
Parts supplied for model: WMT50011K and KMBT5011K
PART
Trim kit frame (slim)
Cooling duct (slim)
Rail (slim)
2
INSTALLATION REQUIREMENTS
Phillips screwdriver
■
SCREW ART QTY
PART ART
QTY
1
2
2
Parts supplied for model: WMT55511K and KMBT5511K
PART
Trim kit frame
(standard)
Cooling duct (standard)
Rail (standard)
14
6
Parts supplied for all models
PART
10
Turntable
Turntable ring
Turntable driver
NOTE: The turntable driver is located inside the microwave oven
cavity. Remove the tape before use.
PART ART
PART ART
QTY
1
2
2
QTY
1
1
1
Tabla de contenido
