Appendix
Troubleshooting
en
Should problems arise with the babyphone, please refer to the following information first.
In the case of technical problems, contact our Gigaset Hotline.
In the case of claims under the terms of guarantee, contact your sales outlet.
Problem
The Power LED does not light up
when connecting the unit to the
mains.
The light on the parent unit is flas-
hing and you cannot hear the sounds
from your baby's room.
Can't hear your baby on the parent
unit, but the light is still glowing
steadily.
The Power LED on the parent unit is
flashing.
Your baby monitor is emitting an
high pitched ear-piercing noise.
Disposal
Batteries should not be disposed of in general household waste. Observe the local waste
disposal regulations, details of which can be obtained from your local authority.
All electrical and electronic products should be disposed of separately from the municipal waste
stream via designated collection facilities appointed by the government or the local authorities.
This crossed-out wheeled bin symbol on the product means the product is
covered by the European Directive 2002/96/EC. The correct disposal and separate
collection of your old appliance will help prevent potential negative consequences
for the environment and human health. It is a precondition for reuse and
recycling of used electrical and electronic equipment.
For more detailed information about disposal of your old appliance, please contact your local
council refuse centre or the original supplier of the product.
Solution
· Check whether there is a power failure. Check
whether all connections are ok and both units are
switched on (on/off key).
· You may have moved out of range − move closer
to the baby unit and wait 5 seconds for the "Link"
to establish.
· You may need to re-establish the "Link" between
the two units. Turn both units off and then:
On the baby unit:
On the parent unit: Press and hold down the
· Check the volume is turned up on the parent unit.
· The rechargeable batteries are nearly exhausted.
Connect the parent unit to the charger.
· This may happen if your parent and baby units are
too close together. Move them further apart.
30
Press the On/Off key.
On/Off key for approx.
2 seconds. The green "Link"
light comes on (this may take
a few seconds).