Craftsman 580.752400 Manual Del Propietário página 16

ENGINE MAINTENANCE
VVARN[NG
WHEN ADJUSTING OR MAKmNGREPAIRS TO YOUR
PRESSURE WASHER
Disconnect the
spark plug
wire from the
spark plug
and
place
the wire where it cannot contact
spark plug.
WHEN TESTBNGFOR ENGINE SPARK
Use
approved spark plug
tester.
DO NOT check for
spark with spark plug
removed,
Checking 0+[ Level
Oi[ level should be checked prior to each use or at
least every 5 hours of operation. Keep o+l level
maintained.
Changing OH
Change engine oil after the first 5 hours and every
50 hours thereafter. If you are using your pressure
washer under extremely dirty or dusty conditions, or in
extremely hot weather, change oil more often.
[ ,A cAu++o.
5. Wipe dipstick clean, insert it into oil fill hole and
tighten securely, remove dipstick. Add
recommended oil up to "Full" mark on dipstick.
Pour slowly. Wipe dipstick clean each time oil
level is checked. DO NOT overfill.
6. [nstail oil fill plug and dipstick, tighten securely.
7. Wipe up any remaining oil.
8. Reconnect spark plug wire to spark plug.
Service Air Cleaner
Your engine will not run properly and may be
damaged if you run it with a dirty air cleaner.
Service the air cleaner once every 25 hours of
operation or once each year, whichever comes first.
Service more often if operating under dirty or dusty
conditions. Replacements are ava+iabie at your local
Sears service center.
To service the air cleaner, follow these steps:
1. Loosen screw and tilt cover down.
Tabs and Slots
Cartridge
• Used motor oil has been shown to cause skin cancer in
certain laboratory animals,
• Thoroughly wash exposed areas with soap and water,
KEEP OUT OF REACH OF CHILDREN.
DON'T POLLUTE. CONSERVE
RESOURCES. RETURN USED OIL TO
COLLECTION CENTERS.
Change oHwhile engine is still warm from running, as
follows:
1. Drain fuel tank by running pressure washer until
fuel tank is empty.
2. Disconnect spark plug wire and keep it away from
spark plug.
3. Clean area around oil fill, remove oil fill
cap/dipstick. Wipe dipstick clean.
4. Tip your pressure washer to drain oi[ from oi[ fiJ[
into a suitabJe container making sure you tip your
unit away from spark plug. When crankcase is
empty, return pressure washer to upright position.
Base
Screw Cover
2. Carefully remove cartridge assembly.
3. To clean cartridge, gently tap pleated paper side
on a flat surface.
4. Reinstall clean or new cartridge assembly inside
cover.
5. Insert cover's tabs into slots in bottom of base.
6. Tilt cover up and tighten screw securely to base.
NOTE: You can purchase new air filter elements by
ca[i+ng 1-800-366-PART.
16