If Your Console Cannot Find The Acoustimass; Module; Adaptiq ® Audio Calibration Error Messages - Bose SoundTouch 130 Guia Del Usuario

If your console cannot find the Acoustimass

The Acoustimass module and console are paired at the factory. However, if you
see the error message Cannot find Acoustimass on the display, perform this
pairing procedure:
1. Unplug the Acoustimass module.
2.
Press on the remote control.
3. Press until 15 PAIR ACOUSTIMASS appears on the display.
4.
Press .
Plug in Acoustimass appears on the display.
5.
Plug the AC power cord into an AC (mains) outlet.
After the Acoustimass module connects to the console, Pairing complete
appears on the display.
Note: For alternate connection options due to excessive wireless interference,
contact customer service.
ADAPTiQ audio calibration error messages
®
Listen to the voice prompts for the following error messages:
Error
message
Problem
1 The microphone on the ADAPTiQ
headset cannot detect sound.
2 The room is too loud.
3 The ADAPTiQ headset is too
close to the speakers.
4 The listening locations are
too similar.
5 The ADAPTiQ headset cannot
take measurements due to
movement.
After correcting your problem, you must restart the ADAPTiQ audio calibration
(see page 21). If you hear a different error message, call Bose customer service
for further instructions. Refer to the contact sheet in the carton.
Care and Maintenance

module

®
What to do
• Secure all speaker cables.
• Ensure the microphone opening on the
top of ADAPTiQ headset is
not blocked.
• Your ADAPTiQ headset may be
damaged. Call Bose
for replacement parts. Refer to the
contact sheet in the carton.
Restart the ADAPTiQ audio calibration
when the room is quiet.
Move the ADAPTiQ headset farther away
from the speakers.
Move 1 - 2 ft. (.3 - .6 m) away from your
previous listening location.
Hold your head still.
customer service
®
English - 37