Troubleshooting - AL-KO AMS2 Manual De Instrucciones

Hitching up the caravan
Working steps
1. Manoeuvre your caravan over the tow hitch of your towing vehicle.
2. Hitch up the caravan correctly.
3. Apply the caravan's handbrake.
CAUTION!
The caravan may make a slight rocking movement when the drives are retracted, de-
pending on the last manoeuvre and the resulting stresses in the axles.
Do not park the caravan with its axles stressed/locked up.
After performing tight cornering manoeuvres or pivoting on the spot, move the ca-
ravan in a straight line forwards or backwards for at least 1 metre.
4. Then move the drives away from the wheels.
Make sure there is a gap of at least 20 mm between the drive and the wheel.
If the distance is smaller and/or the drives do not move away from the wheels, this means the
drives must be moved away manually (fig. 8).
5. Check whether all drives are correctly retracted.
6. Release your caravan's handbrake before driving off.

TROUBLESHOOTING

Malfunction
The remote control does not
perform an LED test when swit-
ched on
Initial start-up cannot be perfor-
med
The system does not establish
a radio link (operation LED on
the remote control does not
show continuous green after a
positioning attempt)
694 570_b
Possible cause
Batteries flat
Remote control defective
Supply battery for the drives is
flat, defective, not connected
Fuse removed or defective
Remote control defective
System defective
No initial start-up performed
Error during initial start-up
No teach-in of new remote con-
trol
Release line defective
Solution
Renew the batteries of the re-
mote control
Renew the remote control and
repeat the teach-in
Check the battery, charge, re-
new or connect it up as requi-
red
Check the fuse
Check the battery/remote con-
trol, renew
Contact an AL-KO service
centre
Repeat initial start-up
Fit a new release line. (As a
temporary solution, the release
button on the F-C-A can be
used for releasing the system)
33