Filling Solution Tank - Nobles Speed Scrub 2001 Manual De Operación Y De Piezas

OPERATION
6. (For Pad Installation) Attach pad to pad driver
before installing driver to motor hub. To attach
pad, remove plastic centerlock from pad driver
and position pad centered on driver, replace
centerlock securely (Figure 4).
FIG. 4
7. Attach brush/pad driver to motor hub. Align 3
mounting studs with slots in motor hub and give
the driver a quick turn toward the spring clip on the
motor hub to attach brush/pad driver. Be certain
that spring clip locks into one of the studs on the
driver before operating machine (Figure 5).
FIG. 5
8. Raise brush head. To raise brush head, step down
firmly on the bottom brush lift foot pedal until brush
locks into the raised position (Figure 6).
FIG. 6
6

FILLING SOLUTION TANK

1. Push machine to fill station. Raise squeegee and
2. Pull solution flow lever completely back to shut off
3. Open solution fill door at front of machine and fill
an explosion or fire. Do not use flammable
materials in tank(s).
NOTE: If filling with a bucket be certain that bucket is
clean. This will prevent the chance of clogging the
solution lines.
4. Add cleaning detergent according to mixing
FOR SAFETY: When using machine, follow
mixing and handling instructions on chemical
containers.
ATTENTION: Use only recommended cleaning
detergents, DO NOT use substitutes. Consult an
authorized distributor for cleaning detergent
recommendations.
Home Find... Go To..
brush head when transporting.
solution flow (Figure 7).
FIG. 7
solution tank with 38L (10 gal) of clean water,
60°C (140°F) maximum temperature. Or use the
rear fill port to fill solution tank. The clear tube
below the fill port has 19L (5 gal) increment
markers to indicate amount of water in tank
(Figure 8).
WARNING: Flammable materials can cause
FIG. 8
instructions on bottle.
Speed Scrubt 2001 Electric (11–01)