Troubleshooting - CLIPIC STREPPER ST50 Manual Del Usuario

Troubleshooting

If the engine can't be started, please perform the following checks to find out the reasons.
(1) Whether there are sufficient fuel in the fuel tank.
(2) Whether the fuel flows from the fuel cock into the carburettor.
(3) Cut off the fuel lever from the carburettor, turn the fuel cock to "OFF" position to see
whether the fuel flows from the fuel pipe.
(4) If it is certain that the fuel has flowed into carburettor, the fuel line is normal, then check
the ignition eyetem.
WARNING
Do not let fuel run off, always keep it in a Vessel. Do not splash gasoline on warm en-
gine and air exhausting pipe, keep away from or open flame, never near any fire source
or heat source while performing this test.
(1) Take off spark plug and connect it again to the entrance spark plug cap.
(2) Turn ignition switch to ON position, algn the spark plug to engine and start the engine,
aif the ignition system works normally, the blue flare flashed across the spark plug gap; if the-
re is no flare, it needs to repair and contact the CLIPIC dealer.
TROUBLESHOOTING
125