Inglesina TRILOGY Instrucciones De Uso página 25

of the relative housings on the pushchair seat (R10).
(R9
ATTACHING THE HOOD
The hood is mounted onto the stroller by positioning it in correspondence of the 2
housings (R11) on the pushchair seat and inserting the slides (H1), pushing until they both
click into place.
Fasten the press studs of the lining to the backrest, starting with the upper ones
(H2) and then with the lower ones (H3).
DETACHING THE HOOD FROM THE STROLLER
To remove the hood from the stroller, unfasten the press studs that secure the
lining to the backrest (H2-H3).
(R11) on the pushchair seat.
HOOD LINING MAINTENANCE
The hood lining can be removed to allow for its correct maintenance. Unfasten the
buttons (H6
To remount the lining, insert both bindings (H8) in the guides on the internal
lining.
Insert the bindings (H8
RAIN COVER (IF AVAILABLE)
To mount rain cover (R3), place it on the hood and button up the snap fastners on
the side (P1).
Fasten the elastic straps (P2) around the front tubes, in correspondence of the
wheel assembly.
MAINTENANCE OF THE LINING
It is recommended to remove the lining periodically to provide for its correct maintenance.
Detach the two lower elastic straps (R12) from the footrest, removing it from its
supports (R14).
Unfasten the buttons on the seat (R15).
Remove the elastic strap (R16) and unfasten the buttons (R17) on both sides of
the pushchair seat.
Unfasten the buttons on the eyelets and on the backrest (R18).
Extract the shoulder pads from the back straps.
Remove the waist strap from the side loops (R8
tooth of the central buckle pass through the side loop before removing it completely.
Pass the shoulder straps and the crotch strap through the eyelets on the lining and
remove it completely.
WARNING: make sure that the lining has been properly reassembled before use.
H5) and simultaneously extract the hood from the housings
H7).
H7) from the binding (H8) and remove the lining.
H7), until fully attached.
25