Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WARNING: TO
AVOID SERIOUS
INJURY, BEFORE PERFORMING
ANY
SERVICE OR ADJUSTMENTS:
1. Depress brake pedal fully and set parking brake.
2. Place attachment
clutch
in "DISENGAGED"
position.
3. Turn ignition key to "STOP" and remove key.
4. Make sure the blades and all moving parts have completely
stopped.
5. Disconnect
spark plug wire from spark plug and place wire where it cannot
come in contact with plug.
TO REMOVE MOWER
1.
Place
attachment
clutch
in "DISEN-
GAGED"
position.
2.
Lower
attachment
lift lever to its lowest
position.
3.
Disengage
belttension
rod (K) from lock
_
bracket
(L).
CAUTION:
Belt tension
rod is spring load-
ed. Have atight grip on rod and release slowly.
4.
Remove
mower
belt from electric
clutch
pulley
(M).
5.
Disconnect
front
link
(E) from
mower
- remove
retainer
spring
and washer.
6.
Go to either
side of mower
and discon-
nect
mower
suspension
arm
(A) from
chassis
and rear
lift link (C) from
rear
mower
bracket
(D) - remove
retainer
springs
and washers.
7.
Goto other side of mower and disconnect
CAUTION: After rear lift links are discon-
nected, the attachment
lift lever will be spring
loaded. Have a tight grip on lift lever when
changing position of the lever.
8. From right side of mower, disconnect
anti-sway bar (S) from right rear mower
bracket (D) - remove retainer spring and
washer and pull mower toward you until
the bar falls from the hole in bracket.
9. Turn tractor steering wheel to the left as
far as it will go.
10. Slide mower out from under right side of
tractor.
TO INSTALL
MOWER
Follow
procedure
described
in "INSTALL
MOWER
AND DRIVE
BELT"in
theAssembly
section
of this manual.
the suspension
arm and rear lift link.
02937
24
Tabla de contenido
