Important - Sears Craftsman 917.288460 Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

• The attachments
can be used during
the
engine warm-up
period after the transmis-
sion has been warmed
up and may require
the choke
control
be pulled
out slightly.
NOTE:
If at a high
altitude
(above
3000
feet)
or in cold temperatures
(below
32 F)
the carburetor
fuel mixture
may need to be
adjusted
for best engine
performance
(see
"TOAD JUST CARBU RETO R"in the Service
and Adjustments
section
of this manual).
PURGE
TRANSMISSION
,_,CAUTION:
Never engage or disengage
freewheel
lever while the engine is running.
To ensure proper operation and performance,
it is recommended
that the transmission
be
purged before operating tractor for the first
time. This procedure will remove any trapped
air inside the transmission
which may have
developed
during shipping
of your tractor.
IMPORTANT:
Should
your
transmission
require removal for service or replacement,
it should be purged after reinstallation
before
operating the tractor.
1. Place tractor
safely on a level surface
- that is clear of objects and open - with
engine off and parking brake set.
2. Disengage
transmission
by placing
freewheel control in disengaged
position
(See "TO TRANSPORT"
in this section
of manual).
3. Sitting in the tractor seat, start engine.
After the engine is running, move throttle
control to slow position. Disengage park-
ing brake.
_IbOAUTION:
At any time, during step 4,
there may be movement of the drive wheels.
4. Depress forward drive pedal to full forward
position and hold for five (5) seconds and
release
pedal.
Depress
reverse
drive
pedal to full reverse
position and hold
for five (5) seconds and release pedal.
Repeat this procedure
three (3) times.
5. Shutoff engine and set parking brake.
6. Engagetransmission
by placing freewheel
control
in engaged
position
(See "TO
TRANS PORT" in this section of manual).
7. Sitting in the tractor
seat, start engine.
After the engine is running, move throttle
control to half (1/2) speed.
Disengage
parking brake.
8. Drive tractor forward for approximately
five feet then backwards
for five feet.
Repeatthisdriving
procedurethreetimes.
Your transmission
is now purged and now
ready for normal operation.
MOWING TIPS
• Tire
chains
cannot
be used
when
the
mower
housing
is attached
to tractor.
Mower
should
be properly
leveled
for best
mowing
performance.
See "TO LEVEL
MOWER
HOUSING"
in the Service
and
Adjustments
section
of this manual.
• The
left hand
side
of mower
should
be
used for trimming.
Drive so that clippings
are discharged
onto
the area that has already
been cut.
Have
the cut area to the right of the tractor.
This
will result
in a more
even
distribution
of
clippings
and more
uniform
cutting.
• When
mowing
large areas, start by turning
to the right so that clippings
will discharge
away
from
shrubs,
fences,
driveways,
etc.
After
one or two rounds,
mow in the
opposite
direction
making
left hand turns
until finished.
f
1
J
If grass is extremely
tall, it should
be mowed
twice to reduce
load and possible
fire haz-
ard from dried clippings.
Makefirstcut
rela-
tively high; the second to the desired
height.
Do not mowgrasswhen
it iswet.
Wet grass
will
plug
mower
and
leave
undesirable
clumps.
Allow grass to dry before
mowing.
Always
operate
engine
at full
throttle
when
mowing
to assure
better
mowing
performance
and proper discharge
of mate-
rial.
Regulate
ground
speed
by selecting
a low enough
speed
to give
the
mower
cutting
performance
as well as the quality
of cut desired.
When
operating
attachments,
select
a
ground
speed
that will suit the terrain
and
give best performance
of the attachment
being
used.
18
Tabla de contenido
loading

Tabla de contenido