TECshow NEBULA TRI Manual De Usuario página 4

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

2. SAFETY INTRODUCTIONS
Please keep this User Guide for future consulta-
tion. If you sell the unit to another user, be sure
that they also receive this instruction booklet.
All fixtures are intact from the manufacturer,
please operate follow up the user manual, arti-
ficial fault are not under guarantee repair.
Unpack and check carefully that there is no
transportation damage before using the unit.
The unit is for indoor use only. Use only in a dry
location.
Do install and operate by operator.
Use safety chain when fixes the unit. Don't han-
dle the unit by taking its head only, but always
by taking its base.
The unit must be installed in a location with ad-
equate ventilation, at least 50cm from adjacent
surfaces.
Be sure that no ventilation slots are blocked,
otherwise the unit will be overheated.
Before operating, ensure that the voltage and
frequency of power supply match the power
requirements of the unit.
It's important to ground the yellow/green con-
ductor to earth in order to avoid electric shock.
Maximum ambient temperature TA : 40°. Don't
operate it where the temperature is higher than
this.
Don't connect the device to any dimmer pack.
First run, there will be smoke or smells, and all
disappearing a few minutes later.
Make sure there are no flammable materials
close to the unit while operating, as it is fire
hazard.
P. 4
Nebula Tri |
English version
Please read the instructions carefully which includes important
information about the installation, operation and maintenance.
WARNING!
Look over power wires carefully, replace im-
mediately if there is any damage.
Never run on for a long time lest shortening
lifespan. Avoid any inflammable liquids, water
or metal objects entering the unit.
Once it happen, cut off the mains power imme-
diately.
Do not operate in dirty and dusty environ-
ment, also cleaning fixtures regularly.
Do not allow children to operate the fixture.
Do not touch any wire during operation as
there might be a hazard of electric shock.
Avoid power wires together around other
cables.
Disconnect mains power before fuse/lamp
replacement or servicing.
Replace fuse only with the same type.
In the event of serious operating problem,
stop using the unit immediately.
Never turn on and off the unit time after time.
The housing, the lenses, or the ultraviolet filter
must be replaced if they are visibly damaged.
Do not open the unit as there are no user ser-
viceable parts inside.
Never try to repair the unit by yourself. Re-
pairs carried out by unskilled people can lead
to damage or malfunction. Please contact
the nearest authorized technical assistance
center.
Disconnect the mains power if the fixture is
not used for a long time.
Do use original packing materials once trans-

Hide quick links:

Tabla de contenido
loading

Tabla de contenido