Italiana Camini MARIÙ Instalación Uso Y Mantenimiento página 19

MOUNTING THE STOVE COVERING MADE OF
CERAMIC TILES
Parts of the stove covering
The stove covering consists of the following parts:
• 8 lateral tiles (11)
• top ceramic insert (13)
• ceramic insert (14)
• rear plate that blocks the tiles (12)
• 2 aluminium profiles (10)
NOTE
The numbers reflect those in the figures (page 76) where
the codes are found.
Stove covering assembly
WITHOUT REMOVING THE TOP, after having
installed the stove correctly, proceed as follows.
Lateral ceramic tiles.
Proceed as follows to mount the ceramic tiles on to the
sides of the stove:
− Loosen the fastening bolts on the left and right of the
rear plates that block the tiles (part n° 12).
− Place the 870 mm long 10x2 gasket (code 425810) onto
the lateral plate that is on the back part of the galvanised
side; both left and right (fig. 2).
− Place the ceramic tiles.
− Put the rear plates that block the tiles back into place
and tighten the bolts.
Ceramic top.
This component (13) is placed into the appropriate
grooves the following is recommended to guarantee
greater stability:
- position the seals ('X') in the ceramics box, as shown in
fig.3.
Ceramic insert (14)
USE SILICONE to set this in component 79.
MOUNTING THE STOVE COVERING
MADE OF STEEL
(detail n° 89 code list page 76)
The stove is delivered with the sides already assembled.
To dismantle them, loosen the 8 bolts at the back that
fasten the two lateral panels and remove them from the
aluminium plates (part n° 10).
FIG. 1
FIG. 2
NOTE
The numbers reflect those in the figures (page
76) where the codes are found.
"X"
"X"
FIG. 3
- 19
-
"X"
"X"