Technical Specifications - Bentel Security AMB10 Manual Del Usuario

AMB10 - 15 - 20
1. INTRODUCTION
AMB is a fully wireless, battery-powered infrared beam barrier for the protection of doors and windows with
alarm radio transmission, that allows a completely wireless installation.
The barrier is made up of two aluminium sections housing the infrared beam transmitters and receivers, closed
by two black polycarbonate covers. The assembled sections may be cut to size and hence perfectly adapted to
the height of the passageway to be protected.
The base unit comprises a master and a slave card which may be expanded to generate additional beams
(AMB-EX) up to a maximum of 8.
The additional beams may be freely positioned inside the sections so as to fully adapt the protection to all
installation requirements. For yet even greater installation flexibility, sections are available in various sizes (from
1 m to 2 m).
Profiles are firmly secured by means of screws and O rings and plugs are especially shaped to always ensure
against any screw or O ring loosening, thus also making for perfectly safe outdoor installation.

2. TECHNICAL SPECIFICATIONS

Power
Consumption
Battery life
Tripping time
Alarm frequency
Infrared beam range
Beam wave length
Tripping logic
Outputs
Alarm type with AMB-TX
radio module
Supervision interval
Operative temperature
Radio transmission
frequency
Radio transmission
range
Code type
Settings
Signals
Controls
- 3.6 V with 2 AA format, 2.7Ah Lithium-Thionyl Chloride batteries
- alternatively, connection to a terminal strip for 12 VDC powering or to a connector
for 3.6 V off-board battery pack powering.
- 280 µA with 2 beams in standby
- 550 µA with 4 beams in standby
- 10 mA during radio transmission of the AMB-TX module
Min 18 months with 2 beams and supervision function enabled
Min 10 months with 4 beams and supervision function enabled
ATTENTION: in cases where there are an elevated number of daily crossings of the
barrier, or there are unfavourable temperature conditions or the barrier be exposed
to direct sunlight, the battery duration could be reduced.
300 ms or 900 ms, selectable via FUNCTION dip-switch
an interval of at least 10-seconds between one alarm and the other.
7 meters indoor, 5 meters outdoors (wall flush mounting)
950 nm
1 or 2 beam break-off, selectable via FUNCTION dip-switch
via radio with 5-channel, 433 MHz AMB-TX transmitter
BEAM BREAK-OFF, BEAM RESETTING, FLAT BATTERY, SUPERVISION
(disabled through jumper), TAMPER (disabled through jumper), END TAMPER
8 minutes
-20 °C ÷ +55 °C
433.92 MHz
150 m outdoors
Unique for each barrier, with proprietary rolling algorithm
Triggering-time selection
Triggering-logic selection (1 or 2 beam cut-off)
Enabled beam selection
BUZZER indicating beam alignment (enabled only during alignment procedure) and
flat battery status
LED indicating radio transmission (disable by acting on the jumper)
RESET button to get barrier running.
ALIGN/RADIO button to perform alignment and barrier test.
ENGLISH
9
ISFSLIMRFWL_05_08.doc