Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
High-impedance (70V/100V line) (100W x 1 channel)
100W @ 70V or 100V
1. Select 70V/100V position using the switch (9).
2. Set the speaker output to high-impedance by setting the DIP Switch number 4 (8), according
to loudspeakers value [100V] or [70V] corresponding to the maximum output voltage.
3. Use speaker cables to connect the [SPEAKERS A]
of the speakers, and the [SPEAKERS B]
In case of high-impedance connection,
Note :The speaker output is processed through a high pass filter (80Hz, 18dB/oct.).
Note: Before operates the unit in this mode, please, check the switch (9)
position (70/100V position)
Low-impedance (2x 50W @
50W @ 8Ω
Note :Take into account the maximum power loaded per channel (50W @ 8Ω)
Note: In low impedance DOES NOT EXIST Bridge mode. Therefore, the
usual bridge connection (using both + terminals), are used ONLY in high
impedance mode.
terminal to the negative "-" terminals.
terminals MUST NOT BE CONNECTED
8Ω
)
50W @ 8Ω
1. Select 8
2. Use speaker cables to connect the
3. Use speaker cables to connect the
PAGE 5
DIP switch body
Maximum output voltage:100V
8
Maximum output voltage:70V
terminal to the positive "+" terminals
position using the switch (9).
Ω/16Ω
[SPEAKERS A]
,
terminals of the loaded speakers,
[SPEAKERS B]
,
terminals of the loaded speakers,
User Manual
/ Manual de uso
8
terminals to the +, -
terminals to the +, -
PA 100
Tabla de contenido
