Programming Menu; Default Parameters; Table: Parameter Sets; Setting The Basic Function - Kübler CODIX 923 Manual De Instrucciones

7.8

Programming Menu

7.8.1 Default parameters

Note: Three default parameter
sets have been permanently
stored; these can be adapted as
required. With each
acknowledgment of the
parameter sets, all parameters
will be reset to the values listed
in the table.
The dEFAuL P.USEr can be
freely programmed.
Mainmenu Parameter Sets
Default setting
Parameter set 1
Default setting
Parameter set 2
Default setting
Parameter set 3
Freely programmable
User settings
Factory settings are highlighted
in grey

7.8.2 Table: Parameter Sets

P.SEt 1
Func Count
InP.PoL PnP
FiLtEr on
Count Cnt.dir
MPi LAtch
Loc.InP ProG
www.kuebler.com
The text SAVE is
displayed for 2 s
P.SEt 2 P.SET 3
Count Count
PnP PnP
oFF oFF
uP.dn Quad
LAtch Set
ProG ProG
P.SEt 1
ModE Add
FActor 01.0000
diViSo 01.0000
dP 0
SEtPt 000000
CoLor red.Grn
rESmd Man.EL
Pr.Out 1
t.Out 1
7.8.3 Setting the Mainmenu basic
Function
Mainmenu basic function
Programming menu

Pulse counter (7.8.4)

Programming menu
Timer/Hour meter (7.8.6)
Programming menu
Tacho/Frequency meter (7.8.5)
7.8.4 Pulse Counter
7.8.4.1 Mainmenu for the Signal and
Control inputs
Mainmenu for programming the
signal and control inputs
Input polarity
PNP: switching to Plus
for all inputs in common
NPN: switching to 0 V
for all inputs in common
P.SEt 2 P.SET 3
Sub Add
01.0000 01.0000
01.0000 01.0000
0 0.00
000000 0000.00
red.Grn red.Grn
Man.EL Man.EL
00.10
Page 7