Forming The Piping - LG UU42W Manual De Instalación

Flaring Work and Connection of Piping

Forming the piping

Form the piping by wrapping the
connecting portion of the indoor
unit with insulation material and
secure it with two kinds of vinyl
tape.
• If you want to connect an additional drain
hose, the end of the drain outlet should be
routed above the ground. Secure the drain
hose appropriately.
In cases where the outdoor unit is
installed below the indoor unit
perform the following.
1. Tape the piping, drain hose and connecting
cable from down to up.
2. Secure the tapped piping along the exterior
wall using saddle or equivalent.
In cases where the Outdoor unit is
installed above the Indoor unit
perform the following.
1. Tape the piping and connecting cable from
down to up.
2. Secure the taped piping along the exterior
wall. Form a trap to prevent water entering
the room.
3. Fix the piping onto the wall by saddle or
equivalent.
22 Air Conditioner
Seal a small
opening around
the pipings with
gum type sealer.
Seal a small Seal a small
opening around opening around
the pipings with the pipings with
gum type sealant. gum type sealer.
• Trap is required to prevent water from entering
into electrical parts.
Trap
Plastic
band
Taping
Drain hose
Plastic Plastic
band band
Pipings
Connecting
cable
Power supply
cord
Seal a small opening Seal a small opening
around the pipings around the pipings
with gum type sealer. with gum type sealant.
Trap Trap
Seal a small opening
Trap
around the pipings
with gum type sealer.