Electrical Safety - Ferax FTS-710 Manual De Instrucciones

• Always remove the plug from the mains socket before carrying out any work on the
machine.
• Do not carry the machine by the cable.
• Incorrect handling may damage the machine. Therefore always comply with the
following instructions.
• Use only sharp saw blades in perfect condition; replace cracked, distorted or blunt
saw blades immediately.
• Machine should only be switched on with blade installed
• Select tools, stroke rate and pendulum actions according to material, Take care to
maintain a constant reed rate.
• Do not attempt to stop the saw blade with lateral pressure after switching off.
• Only use genuine accessories.
• Always use the correct supply voltage. The voltage specifications on the rating plate
must correspond with the mains voltage. Equipment marked with 230 V can also be
connected to 220-240 V.
GB
IMMeDIATeLY sWITCH OFF THe MACHINe WHeN:
• Excessive sparking of the carbon brushes and verticiliosis in the collector.
• Interruption in the mains plug, mains lead or mains lead damage.
• Defect switch.
• Smoke or stench of scorched insulation.

eLeCTRICAL sAFeTY

 A lwayscheckthatthepowersupplycorrespondstothevoltageontherating
plate.
 Y ourmachineisdoubleinsulatedinaccordancewithEN60745;thereforeno
earthwireisrequired.
Replacing cables or plugs
Immediately throw away old cables or plugs when they have been replaced by new
ones. It is dangerous to insert the plug of a loose cable in the wall outlet.
Using extension cables
Only use an approved extension cable suitable for the power input of the machine. The
minimum conductor size is 1.5 mm
completely.
3. OPeRATION
Beforeassembly,alwaysswitchoffthemachineandremovethemainsplugfrom
the mains
Mounting and removing the saw blade (fig. B)
Mounting
• Open the collar (3) by turning it counterclockwise.
36
. When using a cable reel always unwind the reel
2
Ferax