Variable Installation Possibilities: Overlying Installation; Variable Installation Possibilities: Flush Installation - Kuppersbusch KE9340.0 Instrucciones De Uso

7.3 Variable installation possibilities:
Overlying installation
Dimensions in mm
4
4
50
1
Minimum distance to adjacent walls
Opening dimensions
Cutout dimensions
Outer dimensions of the hob
Important:
There is a risk of breakage if the hob is canted or sub-
jected to stress during installation!
Instructions for assembly
4
898
50
860
2
1
7.4 Variable installation possibilities:
Flush installation
Dimensions in mm
2
3
3
50
1
Minimum distance to adjacent walls
Opening dimensions
Cutout dimensions
Outer dimensions of the hob
Glue the sealing tape onto the corner of the supporting
edge of the worktop so that no silicone adhesive can be
pressed under the hob.
Place the hob into the worktop cut-out without any
adhesive and align it. Use shims if necessary.
Fill the gap between the hob and the worktop with heat-re-
sistant silicone adhesive.
Important
Silicone adhesive must not get under the support
surface. If this occurs it will not be possible to
remove the hob again at a later stage. No liability will
be assumed in the case of failure to observe these
instructions.
3
902
+2
50
860
2 1
GB
2
31