Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALL DUCT CONNECTOR
1. Install the damper duct connector onto the
hood using mounting screws (3,9x9,5mm)
as shown in Fig.2
2. Remove the tape located on the damper.
See Fig.2.
INSTALL JUNCTION BOXE
In the area marked "120 VAC INPUT", place
a junction box on the top of the hood. Run the
wires through the hole below and secure with
(2) 3,9 x9,5 screws and (2) washers. See
Fig.3-4.
INSTALL THE DUCTWORK
NOTE: To reduce the risk of fire, use only
metal ductwork.
1. Decide where to install the duct.
2. A straight, short duct will allow the hood to
perform most efficiently.
3. Long duct, elbows, and transitions will
reduce the performance of the hood. Use
as few of them as possible.
4. Use duct tape to seal the joints between
ductwork sections.
Ducted configuration
Install a roof or wall cap. Connect the round metal
ductwork to cap and work back towards hood
location.
Non-Ducted configuration
nstall a decorative grill (not supplied by Best).
I
You may need to purchase a metal round-to-
rectangular transition depending on your
application.
MOUNTING SCREWS
(3,9 x 9,5mm)
"120 VAC INPUT"
P195PM70 Models
(shown in Fig.1a):
(shown in Fig.1b):
MARKED
DUCTED CONFIGURATION
HOOD
24" TO 30" ABOVE
COOKING SURFACE
NON-DUCTED CONFIGURATION
Model:
P195P1M52 - P195P1M70
(6" DUCT CONNECTOR)
MOUNTING SCREWS
(3.9x9.5mm)
REMOVE THE TAPE
MOUNTING SCREWS
(3,9 x 9,5mm)
P195P1M52 Model
Fig.4
- 5 -
ROOF CAP
ROUND
DUCT
WALL
CAP
ROUND
ELBOW
Model:
P195P2M70
(8" DUCT CONNECTOR)
MOUNTING SCREWS
(3.9x9.5mm)
REMOVE THE TAPE
"120 VAC INPUT"
Fig.1a
Fig.1b
Fig.2
MARKED
Fig.3
Tabla de contenido
