Service Parts - NuTone QTXEN150FLT Manual Del Usuario

4. Connect electrical wiring.
Run 120 VAC house wiring to installation lo-
cation. Use proper UL approved connector to
secure house wiring to wiring plate. Connect
wires as shown in wiring diagrams.
5. Insert
mask and
finish
ceiling.
Tape mask
into housing.
Mask protects
unit during
construction.
Remove be-
fore installing
grille.
Install ceiling
material. Cut
out around housing.
6. Attach grille to housing.
Plug light into receptacle. Squeeze grille
springs and insert them into tabs on each
side of housing.
SCREW
WIRNG PLATE & SCREW
FROM PARTS BAG
VENTILATION FAN / LIGHT
7. Push grille against
ceiling.
9. Install light
bulbs.
Product includes
(2) 18W (max.),
type GU24
fluorescent bulbs
with M.O.L.
(maximum overall
length) of 3.9"
(100mm).
Purchase a 4W
incandescent night light bulb. Insert bulbs into their sockets. Replace lens.

SERVICE PARTS

Key No. Part No. Description
1 97020009 Housing
2 97018331 Duct Connector
3 97018721 Parts Bags (includes wiring plate & all screws)
4 97018448 Wire Panel/Harness Assembly
5 97020012 Blower Assembly
6 99140208 Grille Spring (2 req'd)
7 97018533 Grille Assembly (includes key nos. 6 & 8)
8 99111400 Lens
9 99271381 Bulb, GU24, 18W Fluorescent (2 req'd)
10 97018014 Spacer (2 supplied)
11 97020013 Hanger Bar Kit
Order service parts by "Part No." - not by "Key No."
3
10
2
11
5
3
3 4
MODEL QTXEN150FLT
8. Remove light lens.
Carefully insert a small flat-blade
screwdriver between grille and lens.
Pry lens out.
can be ordered on our
website. Please visit us
at www.nutone.com
1
10
3
6
11
7
3
8
9
Page 4
3.9" (100mm) M.O.L.
Replacement parts
99045442A