System Test - Suzuki 990D0-05H01-ALM Manual De Instalación

BURGMAN 650 (AN 650)
a) Dismount the wind shield, the front panel; the front leg shield including the headlights and the meter front panel (follow chapter 9 of the service
manual).
b) Insert deeply the 18-pin harness connector in the alarm unit up to the security catch is clicking.
c) Clean carefully the unit mounting area (pict. 11) and the bottom side of the alarm unit with a suitable cleaner.
d) Mount the alarm unit with the bi-adhesive tape as indicated in pict. 11 and press them for a few seconds.
e) Connect the 1-pin connector (pict. 11
f) Identify the 13-pin turn indicators connector (yellow plug pict. 12
g) Identify the "SIDE STAND RELAY" (wire colour: green; orange/white; yellow/black; black/white) (pict. 13
counterparts.
h) Place the LED as indicated in picture 14
i) Route the wires of the harness and secure them with tie raps "5".
j) Remount the front meter panel, the front leg shield, the front panel and the wind shield and reconnect the negative battery pole.
k) Check and test the system (point 2).

2. SYSTEM TEST

a) To arm the system push once BUTTON 1 of the remote control.
Arming is confirmed by:
2 turn indicators alternated flashing (right-left-right-left)
2 acoustic signals (bleep)
LED turns on (quick flash)
The system is operating after 40 sec. «Standby Time»: the motorbike cannot be started
b) Move the motorbike to test that the movement sensor is operating
c) At the end of the alarm phase the LED is steady ON.
d) To disarm the system push BUTTON 1 of the remote control.
Disarming is confirmed by:
1 turn indicators alternated flashing (right-left)
1 acoustic signal
LED gives 1 flash every 5 sec. to confirm an alarm due to a position variation
ignition key.
e) To activate the PANIC alarm push once BUTTON 2 of the remote control
stop this test push or BUTTON 1 or BUTTON 2).
f) Re-assemble the parts previously removed.
g) End of installation.
3. MOTORBIKE DELIVERY
a) Deliver to the owner the alarm system user instruction and the two remote controls together with the metal plate where the releasing emergency
"PIN CODE" is printed.
b) Explain to the owner the releasing emergency procedure.
I) (+12V) to the plug&play harness counterpart.
J). Interpose the plug&play harness counterparts
L and connect the LED 2-pin connector to the plug&play harness counterpart.
SUZUKI GENUINE ACCESSORIES
Led flashes slowly
siren sounds and turn indicators are flashing during 30 sec.
to reset the alarm memory give an impulse (ON-OFF) on the
the siren sounds and turn indicators are flashing during 30 sec. (to
K) and interpose the plug&play harness
3