Flip A3 Serie Manual De Instrucciones página 20

EN-US English
various settings for the cameras at this
stage, but this is optional.
Figure
Procedure
Note: Only follow the procedure below if
you need to change the IP settings.
1. On the Start menu, click FLIR IP
Config (Start > Programs > FLIR
Systems > FLIR IP Config).
2. In the list of detected cameras, do
one of the following:
• Right-click a camera and select
Modify.
• Select a camera and click
the toolbar.
This will display the IP Address Set-
tings dialog box.
3. In the IP Address Settings dialog
box you can enter new values for the
following parameters:
• IP address
• Subnet mask
• Default gateway
4. Click OK.
Note
If you change the IP address, you need to
restart the camera (dependent on the
camera model). To do this, disconnect
the camera and then reconnect it again
after a few seconds.
20
Step 5: Changing settings
using the camera web
interface
Applicability
This section is dependent on the camera
model.
General
Each camera has a web interface, and
you can change and adjust many camera
settings using this web interface.
Figure
Procedure
on
1. On the Start menu, click FLIR IP
Config (Start > Programs > FLIR
Systems > FLIR IP Config).
2. In the list of detected cameras, do
one of the following:
• Right-click a camera and select
Web.
• Select a camera and click
the toolbar.
• Double-click the camera.
This will open the camera's web
interface in your web browser. If you
see an Install button in the web
interface, an ActiveX component
needs to be installed. To install the
component, click the Install button
and follow the on-screen instructions.
© 2011, FLIR Systems, Inc. All rights reserved worldwide.
on
Publ. no. T559492, rev. 010