Klarstein EasyCook Domino Manual De Instrucciones página 24

EN
24
• The cable connections must be in accordance with the diagram located on the
bottom of the hob .
• You should use a good quality screwdriver to carefully, fully tighten ALL of the
terminal screws.
• If when the hob is first switched on, only two of the zones work, you should
recheck that the terminal screws are all fully tightened. This should be done before
contacting the Customer Care Department.
Note: The appliance must NOT be connected to the mains supply by means of a
13A plug and socket.
• The cable can be looped if necessary, but make sure that is not kinked or trapped
when the hob is in position. Care must be taken to avoid the cable being in contact
with hot parts of the appliance.
Replacing the mains supply cable
If the mains supply cable is damaged, then it must be replaced by an appropriate
replacement. The mains supply cable should be replaced in accordance with the
following instructions:
• Switch the appliance off at the control switch.
• Open the terminal block on the underside of the hob.
• Unscrew the terminal screws fixing the cable.
• The green-yellow earth wire must be connected to the terminal marked
be about 10 mm longer than the live and neutral wires.
• The blue neutral wire must be connected to the terminal marked with letter (N) - the
live wire must be connected to the terminal marked with letter (L).
. It must