Figure 11 Locations Of Tone And Volume Switches - Federal Signal Global G-SND Manual De Instalación Y Mantenimiento

3. Loosen the captive Phillips screw retaining the driver/printed
circuit board (PCB).
4.
Slide out the PCB until the terminals clear the housing. Strip
the wire insulation 5 mm to 6 mm (0.22 in).
5. Follow the instructions starting below for your line voltage
and continue to Step 6 on page 20. Refer to Figure 10 on page
16 for the voltage selector switch and page 21 for the tone
chart.

Figure 11 Locations of tone and volume switches

TONE
SELECTOR
SWITCH
220-240 Vac Operation (no remote switching of tones)
a. Set the voltage selector switch to
b. Turn the tone selector switch to the desired tone.
c. Connect the line (hot) power source wire to the terminal
block position marked
d. Connect the neutral (common) power source wire to the
terminal block position marked
e. Connect ground wire to the terminal block position
marked
Model G-SND Global Series Sounder
Installation and Maintenance Instructions
.
EARTH
.
240
on the PCB. L1
on the PCB.
L2
VOLUME
CONTROL: FULL
CLOCKWISE
= MAX. VOLUME
17