Chicco Cuddle & Bubble comfort Manual De Instrucciones página 11

the front upper tubular frame, lining up the
two pins of basket C1 with the holes in the
tubular (fig. 7).
7. At this point hang the head wash C2 to the
right of the storage basket C1, by sliding it ver-
tically downwards into the guide (fig. 8).
8. Hook the sponge basket C3 to the left of the
storage basket C1 by sliding it vertically down-
wards into the guide (fig. 9).
9. Install the tub B onto the frame A, aligning the
side slots on the tub with the fixing blocks (fig.
11-12). Complete the assembly of the tub by
inserting the rubber plug B1 in the relevant
slot and pressing the base of the plug (fig.11A)
while rotating it in the relevant hole (fig. 11B).
10. Complete assembly by lifting the changing
table A2 and turning it to position it onto the
tub B (fig. 13).
WARNING: to prevent inadvertent rotation of the
changing table A2, make sure that the securing
straps A7 correctly engage clamps A6 through the
release buttons until you hear a click (fig. 13A - 13B).
Using the reducers
To ensure maximum comfort and ergonomics of
the changing table for use in the first months of
a child's life, use the reducer in padded fabric C5
supplied (Fig. 16).
The reducer C5 can be removed or secured to
changing table A2 through the holes and velcro
found on product (fig. 14-15).
WARNINGS FOR THE TUB
• Age of use allowed: from birth up to 12
months and 11kg. For home use only.
• WARNING: To avoid risk of drowning, always
keep the child under hand. The child can
drown in the tub in only a brief time and little
water (2 cm).
• Only an adult may wash the baby.
• Never leave your child unattended.
• Keep all bathing materials near the tub so as to
never leave the child unattended.
• WARNING: To avoid RISK OF DROWNING nev-
er leave the child unattended during the bath.
Do not answer the phone or open the door. Al-
ways take the baby with you if it is necessary to
leave the bathroom.
• Do not use the tub on elevated surfaces (e.g.
tables or the edge of the bath tub for adults).
• Make sure that the supporting surface under
the tub can support it.
• Always make sure that the tub is resting on a
flat, dry and stable surface. The stability of the
tub should be checked before and during use.
• Never turn the child on its stomach inside the
tub.
• WARNING: To avoid burns, before placing the
child in the tub pay attention to water temper-
ature (max 38 ° C - 100 ° F), make sure that the
child cannot access the tap.
• Mix water to avoid hot and cold pockets.
• Before placing the child in the water for the
bath, check that the water temperature with a
thermometer is correct.
• Before filling the tub with water, make sure that
the plug is seated properly.
• Fill the tub up to the MAX level indicated by the
line. It is dangerous to exceed the maximum
filling level of the tub.
• Only one child may use the tub at a time.
• Do not leave objects in the tub when bathing.
• When using the tub make sure that the plug
has been fitted correctly.
• Before placing the child in the water for the
bath, make sure that the changing table is
always secured in place from the side of the
frame.
• Pay attention to appliances and power cables
near the product.
USING THE WASH TUB
The tub B supplied can be used as follows:
• Installed on the frame A (fig. 17).
• To access the tub B turn the changing table A2
over on its back side (fig. 18).
• Before use, fasten the safety strap A8 to the fa-
stening block A6 (fig. 28A).
• Before filling the tub B, make sure that the plug
B1 is correctly closed (fig. 20).
• On a flat surface or inside an adult bath tub (fig. 19).
• Before filling the tub B, make sure that the plug
B1 is correctly closed (fig. 20), making sure to re-
move drain plug and hose B2 by unscrewing it
to ensure product stability (fig. 21).
• Then proceed with filling of the tub B to the
maximum level indicated by the appropriate
symbol on the inner surface of the tub B (fig. 22).
• The hand shower for adults can be temporarily
positioned in the dedicated grip on the short
side of the tub B (fig. 23).
WARNING: Perform this operation before put-
ting the baby inside the tub.
• To empty the tank B, if installed on the frame, it
is advisable to use the special tube B2 (fig 25),
after opening the rubber plug B1 (fig. 24).
• Alternatively, if the tank B is used in a bath tub or
other flat surface, empty it by opening the cap
(Fig. 24) or turning it over to drain the water.
WARNING: Drain water into a drain (e.g. bath, toi-
11