D-Link DCS-60 Guia De Instalacion página 3

Model No.: DCS-60
I . Introduction
The DCS-60 Camera Housing is constructed from die-cast aluminium and is powder coated and stove finished.The design
and manufacture is to the highest technical standard with environmental protection to level IP 44. The Housing is supplied
complete with an adjustable Fully-Cable-Managed Bracket (the concealed cable channel inside the mounting bracket).
II. Mounting configuration of DCS-60
1. Use the rear section of the Mounting Bracket (D) as a template for
marking the position on the wall of the Mounting Holes (H). Remove & drill
to pattern required.
2. Attach the Mounting Bracket arm to the wall using the raw plugs and
screws provided.
3. Feed cables from the main Housing (C) through the hole of the Mounting
Plate (E) on the Mounting Bracket (D), and then feed the cable again to
the concealed channel inside the Mounting Bracket throughout the wall
outlet (A) or bracket outlet (B).
4. Attach the main Housing (C) to the Mounting Plate (E) of the Bracket with
4 of 1/4" x 14.7 mm Trilobular screws (F) provided.
5. Release Screw (G) on the Mounting Bracket to pan and tilt
the Housing. Position the Housing as required for the correct Camera
coverage, and then tighten both screws to secure.
1 Heater
2 Heat shield
3 Thermal control board
4 Camera mounting platform
5 Terminal block assembly
6 Cable conduits PGB11 x 2
7 Captive retaining Screws x 4
8 Heater & blower wires, Ground wire
9 Ground wire
10 Blower
1. Unscrew the 3 captive Retaining Screws (C) and remove the
Housing Cover (A) from the Housing Base (B).
2. Release the 4 Keyhole Screws (F) and then slide and withdraw
the Camera Platform (G) from the Housing Base (B).
3. Mount the Camera (H) onto Platform (G) using the 1/4" UNC
Screw ( I ) supplied, ensuring that the Insulation Pad (J) is
mounted between the Platform and the Camera. Always check
that the Camera is firmly attached to the Platform.
4. Connect the Camera / Heater power cable to the rear Terminal
Block (E) through the first Cable Conduit (D) referring to the
circuit diagram shown in section IV. for the terminal
designations.
5. Connect the video cable to the Camera through the second
Cable Conduit(D).
1
User's Manual