schmalz SCPSi-L Instrucciones De Funcionamiento página 67

IO-Link Data Dictionary
21.10.01.00065/02
208 0x00D0 Permissible leakage rate

Production Setup - Profile P3
220 0x00DC Air saving function
221 0x00DD Disable continuous suction
222 0x00DE Setpoint H1
Hysteresis h1
223 0x00DF
224 0x00E0 Setpoint H2
225 0x00E1 Hysteresis h2
226 0x00E2 Duration automatic blow
Permissible evacuation time
227 0x00E3
228 0x00E4 Permissible leakage rate

Commands
2 0x0002 System command
120 0x0078 CAL Calibrate vacuum sensor
123 0x007B rES Restore to factory defaults

Observation
Process Data In Copy
40 0x0028
41 0x0029 Process Data Out Copy
System vacuum
64 0x0040
66 0x0042 Supply voltage
65 0x0041 Input pressure
J. Schmalz GmbH
2 bytes 1 - 999 rw
1 byte 0 - 2 rw
1 byte 0 - 1 rw
2 bytes 998 >= H1 >= (H2+h1) rw
2 bytes (H1-H2 >= h1 > 10 rw
2 bytes (H1-h1 >= H2 >= (h2+2) rw
2 bytes (H2-2) >= h2 >= 10 rw
2 bytes 100 - 9999 rw
2 bytes 0, 10 - 9999 rw
2 bytes 1 - 999 rw
1 byte wo
1 byte 1 wo
1 byte 1 wo
1 byte (V1.0)
ro
4 bytes (V1.1)
1 byte (V1.0)
ro
2 bytes (V1.1)
2 bytes ro
2 bytes ro
2 bytes 0 - 99 rw
5 of 11
J. Schmalz GmbH
Aacher Straße 29, D 72293 Glatten
Tel.: +49(0)7443/2403-0
Fax: +49(0)7443/2403-259
[email protected]
250
Profile P-3
1
(selected by PD Out 0 - Profile-Set = 3)
0
750
150
550
10
200
2000
250
0x05 (dec 5): Force upload of parameter data into the master
0x82 (dec 130): Restore device parameters to factory defaults
0xA4 (dec 164): Clear diagnostic buffer
0xA5 (dec 165): Calibrate vacuum sensor
1 = Calibrate vacuum sensor
(can also be executed by switching PD Out 0 Bits 2 and 3 simultaneously
from 0 to 1)
1 = Restore to factory defaults
Copy of currently active process data input
Copy of currently active process data output
Current vacuum level (unit: 1 mbar)
Supply voltage as measured by the device (unit: 0.1 Volt)
0 Pressure value from external pressure sensor (unit: 0.1 bar)
SCPSi series
29.08.2014
SCPSi Data Dictionary