ASROCK ConRoeXFire-eSATA2 Manual De Instrucciones página 27

2.10 eSA 2.10 eSAT T T T T AII Inter 2.10 eSA AII Inter AII Inter AII Inter face Introduction face Introduction face Introduction face Introduction
2.10 eSA 2.10 eSA AII Inter face Introduction
What is eSATAII?
This motherboard supports eSATAII interface, the external SATAII specification.
eSATAII allows you to enjoy the SATAII function provided by the I/O of your
computer, offering the high speed data transfer rate up to 3.0Gb/s, and the
convenient mobility like USB. eSATAII is equipped with Hot Plug capability that
enables you to exchange drives easily. For example, with eSATAII interface, you
may simply plug your eSATAII hard disk to the eSATAII ports instead of opening
your chassis to exchange your SATAII hard disk. Currently, on the market, the
data transfer rate of USB 2.0 is up to 480Mb/s, and for IEEE 1394 is up to 400Mb/
s. However, eSATAII provides the data transfer rate up to 3000Mb/s, which is
much higher than USB 2.0 and IEEE 1394, and still keeps the convenience of Hot
Plug feature. Therefore, on the basis of the advantageous transfer speed and the
facilitating mobile capability, in the near future, eSATAII will replace USB 2.0 and
IEEE 1394 to be a trend for external interface.
NOTE: 1. If you set "Configure SATA as" option in BIOS setup to AHCI or RAID mode, Hot
Plug function is supported with eSATAII devices. Therefore, you can insert or
remove your eSATAII devices to the eSATAII ports while the system is power-on and
in working condition.
2. If you set "Configure SATA as" option in BIOS setup to IDE mode, Hot Plug function is not supported with eSATAII devices. If you still want to use eSATAII function in IDE
mode, please insert or remove your eSATAII devices to the eSATAII ports only when
the system is power-off.
3. Please refer to page 32 to 38 for detailed information of RAID mode, IDE mode, and
AHCI mode.
How to install eSATAII?
SATAII_RED (PORT2) and
SATAII_ORANGE (PORT3)
1. If you just plan to install one eSATAII device to this motherboard, it is recom-
mended to enable the bottom eSATAII port of the I/O shield. In order to enable
the bottom eSATAII port of the I/O shield, you need to connect the red SATAII
connector (SATAII_RED; see p.2 No.13) and the red eSATAII connector
(eSATAII_BOTTOM; see p.2 No.36) with a SATA data cable first. Then the
bottom eSATAII port of the I/O shield is enabled.
ASRock ConRoeXFire-eSATA2 Motherboard
eSATAII_TOP and
eSATAII_BOTTOM
2 7 2 7 2 7
2 7 2 7