ASROCK ConRoeXFire-eSATA2 Manual De Instrucciones página 21

FDD connector
(33-pin FLOPPY1)
(see p.2 No. 26)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 10)
connect the blue end
to the motherboard
80-conductor ATA 66/100 cable
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATA II Connectors
(SATAII_BLUE (PORT0):
see p.2, No. 16)
SATAII_RED
(PORT2)
(SATAII_BLACK (PORT1):
see p.2, No. 15)
(SATAII_RED (PORT2):
SATAII_BLUE
see p.2, No. 13) (PORT0)
(SATAII_ORANGE (PORT3):
see p.2, No. 14)
SATAII_RED (PORT2) and SATAII_ORANGE (PORT3) connectors can be
used for internal storage devices or be connected to eSATAII_BOTTOM
and eSATAII_TOP connectors with corresponding color to support eSATAII
devices. Please read "eSATAII Interface Introduction" on page 27 for
details about eSATAII and eSATAII installation procedures.
eSATA II Connectors
(eSATAII_TOP: see p.2, No. 37)
(eSATAII_BOTTOM: see p.2, No. 38)
Serial ATA (SATA)
Data Cable
(Optional)
ASRock ConRoeXFire-eSATA2 Motherboard
the red-striped side to Pin1
connect the black end
to the IDE devices
These four Serial ATA II
(SATAII) connectors support
SATA data cables for internal
SATAII_ORANGE
storage devices. The current
(PORT3)
SATA II interface allows up to
3.0 Gb/s data transfer rate.
SATAII_BLACK
(PORT1)
These two eSATA II
connectors support SATA
data cables for external
SATAII function. The current
eSATA II interface allows up to
3.0 Gb/s data transfer rate.
Either end of the SATA data cable
can be connected to the SATA /
SATAII hard disk or the SATAII
connector on the motherboard.
You can also use the SATA data
cable to connect SATAII connec-
tors and eSATAII connectors
with corresponding color.
2 1 2 1 2 1
2 1 2 1