Flex BME 18.0-EC + LK 152 Instrucciones De Funcionamiento Originales página 36

Use the sander in areas that are particu-

larly hard to reach, e.g. tight interior an-
gles in railing construction.
Do not bring the sanding plate into con-

tact with the workpiece until the full speed
of the tool has been reached.
To achieve good sanding results, move

the sanding plate evenly over the surface
to be sanded down.
Do not impart excessive force.

To achieve perfect radii, use the profiling

block. Use it to profile the sanding plate.
When it is switched off, the sanding plate

continues to run briefly.
Pipe belt sanding attachment BR 50
WARNING!
Remove the battery before carrying out any
work on the power tool.
Fitting or changing the sanding belt
CAUTION!
Observe the prescribed direction of belt
rotation! The direction of rotation must
correspond with the arrow on the gear head.
Remove the battery.

Press the swing arm in the direction of the

drive roller and hold (1.).
Fit the sanding belt over the rollers (2.).

Release the swing arm.

Check that the belt is fitted properly on the

rollers.
36
TRINOXFLEX BME 18.0-EC + LK 152 / + BR 50 / + BF 140 / + BS 50
Mounting the handle
Bring the handle into position on the thread.
Changing the rollers
Drive roller:
Press and hold the spindle lock (1.).

Loosen the drive roller against the direc-

tion of rotation and pull off (2.).
Fit a new drive roller and tighten in the di-

rection of rotation.
Release the spindle lock.

Relay roller:
Loosen the screw using a hexagon key

and pull off the relay roller (3.).
Fit a new relay roller and tighten.
