Columbus AKS 80 Manual De Instrucciones página 26

FAULTS
The machine produces dust.
The machine leaves debris on
the floor.
The battery-operated machine is
not performing to its best, it is
slow and it is not cleaning
properly.
This machine is guaranteed against factory or monitoring defects for 12 months from the date of sale.
The warranty only and exclusively covers the replacement or repair of parts that are faulty. Any other request will not be
accepted.
Damage due to normal wear and tear is not included, use that differs from any intended use reported herein, damage caused by
incorrect adjustments, technical actions that have been carried out incorrectly, acts of vandalism.
1) FILTER SHAKE BUTTON
2) HORN BUTTON
3) WORK LIGHT SWITCH
4) BATTERY LEVEL INDICATOR LIGHT
5) HOUR METER
6) IGNITION KEY
7) GEAR SHIFT
8) HYDRAULIC DISCHARGE SAFETY BUTTON
9) DEBRIS HOPPER DOOR OPEN BUTTON
10) DEBRIS HOPPER LIFT BUTTON
FILTER SHAKE BUTTON:
Detail 1 This is used to make the suction filters vibrate electrically (to clean them), by means of an electric vibrator; it must be
pressed at least 6/7 times for 8/10 seconds every time (this procedure must be carried out before operating the machine, before
emptying out the debris hopper and the motor must be off).
HORN BUTTON:
Detail 2 Press this button to sound the horn (Klaxon).
WORK LIGHT SWITCH:
Detail 3 This is used to turn the work lights on.
BATTERY LEVEL INDICATOR LIGHT:
Detail 4 This indicates the battery level and is represented by three coloured lights (red, yellow and green); by turning the
ignition key Detail 6, the LEDs turn on in the following order: red - yellow - green; wait for the green light to come on
before going into forward drive (or reverse). When the red LED comes on, it is necessary to charge the batteries.
Clogged filter.
Damaged filter.
Filter assembled incorrectly.
Damaged side washers.
The central broom is not adjusted
accordingly, or it is worn.
You have collected wires, cords etc..
Damaged side washers.
The hopper is full.
The battery is low or not completely
charged.
The battery charger you are using is not
the recommended one or it is not
sufficient.
"DSA" HYDRAULIC DISCHARGE
EQUIPMENT ON THE AKS 80|BM 108 DSA CONTROL PANEL - FIG. 19
CAUSES
CHAP. 19 – WARRANTY
26
Vacuum sweeper
REMEDIES
Clean it by 'shaking' it with relative
tools and remove it and clean it
thoroughly, as needed.
Replace it.
Assemble it with its washer and make
sure it is installed correctly and firmly
with even force.
Adjust them or replace them.
Adjust the central broom and check its
'track'.
Remove them.
Change it/them.
Empty it out.
Check the electrolyte level and proceed
with a new, complete charging cycle.
Use a suitable battery charger.
AKS 80|BM 108