HEINE LAMBDA 100 Manual De Instrucciones página 8

Hygienic Reprocessing
The instruction is available:
- at www.heine.com
- in a paper version which you can request from the address listed
Maintenance
Changing the light source
Verify that the lamp voltage complies with the supply voltage of the handle.
Remove the LAMBDA 100 from the HEINE handle. Unscrew the connecting piece
and carefully remove the bulb (5).
Wipe the dome of the new bulb with a clean cloth and place the bulb in the
retinometer.
Screw the connecting piece back on.
Service
The device has no components serviceable by the end-user.
General Notes
The warranty for the entire product is invalidated if non-genuine HEINE products
or non-original parts are used and if repairs or modifications are made to the
device by persons not authorized by HEINE. For more information, please visit
www.heine.com.
The expected life cycle, when the device is normal used and the warning and
safety information as well as the maintenance instructions are observed, is up to
7 years. Beyond this period, the product may continue to be used if it is in a safe
and good condition.
General Warnings
Check the correct operation of the device before use! Do not use the device if
there are visible signs of damage or the light begins to flash.
Do not use the device in fire- or explosive risk area (e.g. oxygen saturated or
anaesthetic environments).
Do not modify the device.
Use only original HEINE parts, spare parts, accessories and power sources.
Repairs shall only be carried out by qualified persons.
Disposal
The product must be recycled as separated electrical and electronic devices.
Please observe the relevant state-specific disposal regulations.
The appendix contains following tables
- Electromagnetic disturbances – Requirements and tests
- Technical specifi cation
- Explanation of the used symbols
8/40
med 2214 2020-06-02