Craftsman 536.886122 Manual De Instrucciones página 7

TO INSTALL SHIFTER LEVER KNOB
Thread the hex nut found in the parts bag
onto shifter lever. Thread the shifter lever
knob onto the threaded end of the shifter
lever until it is snug against the hex nut
and the lip is pointed away from the en-
gine. Tighten hex nut against the bottom
of the shifter lever knob. See figure below.
,, \ Knob
Nut
Shifter Lever
NOTE: If the cables have become discon-
nected, reinstall spring as shown in figure
below.
4" Lg free state
Traction drive 3" Lg free state Auger drive
s ing
TO ASSEMBLE SNOW CHUTE
• Turn crank assembly counterclockwise
until it stops.
• Locate three carriage bolts, flatwashers
and nuts (found in parts bag) for snow
chute flange. DO NOT remove carriage
bolt over worm gear.
- Position snow chute on snow chute flange
and align the three holes in the snow
chute with holes in the snow chute flange
as shown in figure below.
, Install carriage bolts from inside of chute
as shown in figure below, flatwashers and
nuts.
Tighten all four nuts on snow chute flange
securely. See figure below.
Locknut
Chute
Snow Chute Flange
drive Au drive
spring lever spring cable
NOTE: if the cables have become discon-
nected from the clutch levers, reinstall the
cables as shown in figure below.
NOTE: Position cable through slots on
shifter plate.
"Z" fitting
Bolts
d
TO CHECKJADJUST CLUTCH
CONTROL CABLES
The control cables attached to the auger
clutch lever and traction clutch lever as
shown in figure below may need to be ad-
justed before you use your snow thrower.
For instructions on checking or adjusting the
control cables, (See To Adjust Clutch Control
Cables paragraph on page17).
TractionClutchLever Auger ClutchLever
ON
-
\:v ¢
Controlcables
7