Tabla de contenido
Idiomas disponibles
Idiomas disponibles
GENERAL
RECOMMENDATIONS
The-warranty on this snow thrower does not
cmier items that have been subjected to op-
erator abuse or negligence_ To receive full
value from the warranty, the operator must
maintain the snow thrower as instructed in
this manual. The above chart is provided to
assist the operator in properly maintaining
the snow thrower.
Some adjustments will need to be made pe-
riodically to properly maintain your snow
thrower.
AFTER
FIRST
USE
• Check for any loose or damaged parts.
• Tighten any loose fasteners.
, Check and maintain the auger.
• After each use, remove all snow and slush
off the snow thrower to prevent freezing of
auger or controls.
° Check controls to make sure they are
functioning properly.
• if any parts are worn or damaged, replace
immediately.
LUBRICATION
CHART
Lubricate
Plate Zerk
with a Hi Temp EP Moly Grease°
SNOW THROWER
LUBRICATION
- EVERY
25 HOURS
Lubricate Disc Drive Plate eve ry twenty-five
(25) hours and atthe end of the season and/
or before storage.
To Lubricate:
°
u
Position speed
selector
lever in first gear.
Turn disc drive plate clockwise by hand
until grease zerk is clearly
visible at front
center. See figure below.
Friction
Shaft
Wheel
Disc
(Require
No
LubricatiOn)
Friction
Wheel
Bearing
Piacecoinin gap
between friction
wheel and disc drive
_/'plate
[
1
[_Grease
Zerk
Pointatwh
grease
shouldbe visible
• Place a coin or (a shim of equal thick-
ness) between the rubber friction wheel
and disc drive plate to prevent rubber fric-
tion wheel contacting the drive disc.
- To grease zerk, use a hand grease gun,
lubricate with a Hi Temp EP Moly grease
See inset of second figure on this page.
DO NOT over fill or allow grease to come
in contact with the disc drive plate or fric-
tion wheel or damage will result. Fill zerk
only until grease becomes visible below
bearing assembly located under grease
zerk. See insert in figure above.
IMPORTANT: Remove coin and ensure that
a gap exists between friction wheel and disc
drive plate.
NOTE: Clean all excess grease found on
friction disc hub.
CAUTION: Do not allow grease to contact
friction wheel and disc drive plate.
t5
Tabla de contenido
