Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Glass Panel
2
3
1
4
5
6
Inside Shower
5 - iNstaLLatioN oF dooRs
Groove for rollers.
Doors should open and close easily. Close the doors so that
magnetic strips contact each other, in order to see whether
adjustment is required. Top of doors should be at the same
height, and the space between doors, when they close, should
be uniform.
If the two doors require adjustment, raise or lower one of the
roller assemblies (or both of them) using the bottom-mounted
adjustment screw.
6 - iNstaLLatioN oF HaNdLes
1. Start by disassembling the handle set.
2. Insert the aluminum plat (3), the clear gasket (2) and
the round bushing (1) into the special screw (4).
7
8
3. Insert the assembly through the glass panel as shown on
the illustration, the screw head should be on the inside of the
shower.
4. Insert the clear gasket (2) on the screw, on the other side of
the glass panel
5. Repeat step 2 to 4 for the bottom of the handle.
6. Using a Philips screwdriver, tighten the screw (4) onto the
outside handle (8) for the top and bottom of the handle.
7. Insert the inside handle (5) in the screw heads.
8. Using the provided Allen key, tighten the setscrews on the
Outside
screw to secure the handle in place.
Shower
Note: Use the longer side of the Allen key to screw the
setscrews; it can be angled to facilitate the process. Use the
shorter side of the Allen key to securely tighten the setscrews.
9
Turn the screw clockwise to raise, and
counterclockwise to lower.
1
1- Enter the shower cabin. Lift the
door and tilt it forward to be able
to rest the top rollers in the upper
rail grooves.
2
2-
Press
engagement buttons and push for
the doors. Lower rollers must be
aligned in the lower rail grooves.
3- Use the leveling screws on the
bottom of each door panel to move
the door to its heigthest point without
3
forcinge the screws.
Roller bottom view.
the
lower
roller
x2
Tabla de contenido
